Products for temperature measurement - Temperature transmitter
The task of transmitters is the transformation of the sensor signal into a stable and standardized signal. In the past, transmitters were built using analog technology. In the meantime digital technology has gained acceptance, however, because it offers better measurement accuracy at simultaneously higher flexibility, improve safety and safe costs.
In addition, the measurement accuracy in modern transmitters can be improved by use 'sensor-transmittermatching'. The complete measurement point can be calibrated in a loop (Sensor and transmitter together).
On the one hand, the standardized output signal in the process measurement is a 4...20 mA signal, but also the internationally standardized field buses, such as HART, PROFIBUS and FOUNDATION Fieldbus are used. The HART protocol serves mainly for a more convenient operation in combination with the 4...20 mA analog measured signal. PROFIBUS and FOUNDATION Fieldbus, however, transfer the real measured value digitally without any loss of accuracy and therefore offer cost savings by simplifying the wiring.
| Multi-channel transmitters |
MS150 Temperature Multi-channel transmitters |
● Multi-channel input, single output
● 4 to 20 mA analog output
● Galvanic isolation from input to output
● The highest temperature for output displaying
● High accuracy in total ambient temperature range
● IP66（aluminum alloy casing）,IP62（plastic casing）
● Digital display (LED) |
MS151 Temperature Multi-channel transmitters |
● multi-channel input,single output
● 4 to 20 mA analog output
● Only 8 V voltage drop within whole loop circuit
● Galvanic isolation from input to output
● The highest temperature for output displaying
● Fault signal on sensor break circuit
● High accuracy in total ambient temperature range
● Ex-Certification
● IP66（aluminum alloy casing）
● Digital display (LED)
● Anti-RFI- Certification( especially for intercom) |
MS152 Temperature Multi-channel transmitters |
● Multi-channel input; high selector,low selector ,data scaning or digital output
● Universal settings with HART-protocol
● Operation, visualisation and maintenance via PC or HART-protocol
● 2 wire technology, 4 to 20 mA analog output
● High accuracy in total ambient temperature range
● Fault signal on sensor break or short circuit
● Digital display (LED)
● IP66（aluminum alloy casing）
● Galvanic isolation from input to output
● Wide voltage supply range
● Anti-RFI- Certification( especially for intercom)
● Customer specific measurement range setting |
|
|
